The Slimer Build Thread

okay so i hope this helps...

tube off of the compressor...
IMG_20130327_133337_230 (800x600).jpg

tube running back across frame tube...
IMG_20130327_133357_420 (800x600).jpg

and then up and attached...
IMG_20130327_133459_734 (600x800).jpg


hope this is what you were looking for!
 
paychex.308 said:
sh*t that sux. rig looks good though!

andrew -
Click to expand...

Haha thanks! I'm a ferrous metallurgist and I currently work as a failure analysis engineer, dealing mostly with steel. So damaging a product like that just gets my wheels spinning about all the potential stress risers I added into the part that could cause catastrophic failure in the event that I need the stinger to protect my radiator...
 
Prime8 said:
Haha thanks! I'm a ferrous metallurgist and I currently work as a failure analysis engineer, dealing mostly with steel. So damaging a product like that just gets my wheels spinning about all the potential stress risers I added into the part that could cause catastrophic failure in the event that I need the stinger to protect my radiator...
Click to expand...

Damn that took me a couple tries to understand that lol

But alas.. I understand all too well :(
 
silverbackjk said:
Wow The Double "D" flexes really nice man.
Click to expand...

Yeah it does! Three of us looked over the whole undercarriage to make sure everything was good while it was up on the ramp. My rear driveshaft boot barely touches the evap skid. Relocating the evap today and everything should be good!
 
You must log in or register to reply here.
Top Bottom