New Rig - Silver Bullet - DTD, 60/80, 40’s....

Bierpower said:
Like you don't have enough room or not enough wire? I would think you should be able to cut that sheath open and get enough exposed wire to make a joint. You may have to get a roll of heat resistant tape but that sounds a whole lot better than swapping a harness. Maybe you can see something I can't.

Sent from my Pixel 2 XL using WAYALIFE mobile app
Click to expand...

This is just the harness attached to the motor. Not the harness for the entire jeep. They plug into each other.


Sent from my iPhone using WAYALIFE
 
A.J. said:
Anything wrong with the old harness from the other engine? Plug and play. Why the fuck would someone cut that off there?


Sent from my iPhone using WAYALIFE mobile app
Click to expand...

No nothing wrong. Just will be a bitch at this point either way cause it’s a tight space. I’ll look at it tomorrow when I can see the motor.

Stupid that someone would cut that. You can get a new one online for like $30.


Sent from my iPhone using WAYALIFE
 
Ordered a new harness today. $49. Not sure when it’ll be here. Figured it was worth it instead of trying to pull it from the old motor.

Adjustments.jpg


Sent from my iPhone using WAYALIFE
 
OverlanderJK said:
It was the only code I had. I’m okay with that. Lol debating just replacing the whole oil filter housing or just the sensors.


Sent from my iPhone using WAYALIFE
Click to expand...
Yea I guess 1 code after all that really isnt bad. Sucks that the harness was cut, especially being that it was such a tight cut it's almost like the last guy cut it, laughed and said "good luck to the next SOB".

Sent from my SM-N960U using WAYALIFE mobile app
 
benatc1 said:
Yea I guess 1 code after all that really isnt bad. Sucks that the harness was cut, especially being that it was such a tight cut it's almost like the last guy cut it, laughed and said "good luck to the next SOB".

Sent from my SM-N960U using WAYALIFE mobile app
Click to expand...

It had to have been cut after it was removed. You can’t get to that area of the motor unless you take it apart and this had not been taken apart.


Sent from my iPhone using WAYALIFE
 
OverlanderJK said:
It had to have been cut after it was removed. You can’t get to that area of the motor unless you take it apart and this had not been taken apart.


Sent from my iPhone using WAYALIFE
Click to expand...

I’ve had salvage LS engines show up from LKQ with the plug wires cut. Still plugged into the coil pack and spark plugs lol


Sent from my iPhone using WAYALIFE
 
OverlanderJK said:
Ordered a new harness today. $49. Not sure when it’ll be here. Figured it was worth it instead of trying to pull it from the old motor.

View attachment 343165


Sent from my iPhone using WAYALIFE
Click to expand...

I would say unless you absolutely have to, do not order from this place unless you absolutely have to. They have the worst ship times ever. Still has not shipped yet. This is the third time I’ve ordered from them and for sure the last.

Would have been a perfect weekend to get this installed but I guess I need to wait for next weekend. Or maybe the weekend after. Who knows.


Sent from my iPhone using WAYALIFE
 
You must log in or register to reply here.
Top Bottom