UD60s / Fusion 60s

Forgive me, I know this is a bit off topic but didn’t see the need to start a new thread for this question. In regards to dynatrac pr 60 front, I’m assuming that the hubs are unlocked on ”o” and locked on “x” ?
 
Forgive me, I know this is a bit off topic but didn’t see the need to start a new thread for this question. In regards to dynatrac pr 60 front, I’m assuming that the hubs are unlocked on ”o” and locked on “x” ?
That is correct
 
Finally got the green light and I'm gonna get some 1 tons ordered tomorrow.
Talked it over with Dan at fusion again and I have landed on doing their 60/13 set up in 72" and 40 spline rear.

To note for anyone in the market Fusion is 5% off until Dec 3rd and dynatrac looks to be about 15% off on axles depending on which ones right now

Dynatrac trail leader package, trail ready beadlocks and some 37s to be for sale soon if anyone is in the market
 
Finally got the green light and I'm gonna get some 1 tons ordered tomorrow.
Talked it over with Dan at fusion again and I have landed on doing their 60/13 set up in 72" and 40 spline rear.

To note for anyone in the market Fusion is 5% off until Dec 3rd and dynatrac looks to be about 15% off on axles depending on which ones right now
Yes all Dynatrac axles are 15% off on all packages. Congrats on ordering your new axles! Always exciting for sure.
 
Yes all Dynatrac axles are 15% off on all packages. Congrats on ordering your new axles! Always exciting for sure.
Some big steps to the ultimate goal are finally getting checked off the list and it's super exciting. V8 done, 1 tons next, then i get to plan out what I'm gonna do suspension wise. Gonna have to stick with the short arm coil and shock for a bit until I can figure out what steps to take before going all out to stretch the 2dr
 
Congrats on the new axles! Sounds awesome can’t wait to see your finished goal!

Also, I’m looking forward to your review of the Fusions being that they have the kingpin.
 
Last edited:
Top Bottom