The "I don't really have a good name and probably never will" build.

image-3708294239.jpg

I have discovered an unpublished benefit of EVO Jeep parts. Every item that you put on your JK that has the EVO name or logo on it increases your snow traction by 2.6%.
 
Bacon said:
It's the weight. Lol.
Click to expand...

No no. That's not it. The other unpublished benefit is that each piece also DECREASES total gross weight by 1.3%. Also there is a total brake horsepower increase of 3-4 BHP per piece. :brows:
 
image-2323808098.jpg

Not part of the build, per se, but I did need SOMETHING to drive the unibit through the glove compartment for my CB install.
 
Tigrcky said:
I have always liked Milwaukee! I bet an electric 1/2 inch drive impact would be a great trail addition!
Click to expand...

I've got the 1/4 inch drive impact and it is a beast. I use an adapter to use 1/2 sockets when removing lug nuts and it has never let me down.
 
thardy said:
I've got the 1/4 inch drive impact and it is a beast. I use an adapter to use 1/2 sockets when removing lug nuts and it has never let me down.
Click to expand...

Looking at either the 3/8" or 1/2" hex drive impact wrench or pin detent version. Not sure which.
 
Last edited:
Okay, got the Cobra WX 75ST installed today.

IMG_5137.jpg

Not sure how long this unopened bag of jerky has been hiding back there!

IMG_5145.jpg

IMG_5142.jpg

IMG_5144.jpg

IMG_5141.jpg

IMG_5140.jpg

IMG_5147.jpg

IMG_5149.jpg

Not sure why some of these are rotated strangely. Can't seem to figure that out.

Firestik quick disconnect and spring inbound.
 
Last edited:
Looks great! Curious, where did you get that handmike mount from? Im about to install the same CB in my rig, I really like that mount rather than drilling into the dash somewhere.
 
I know quadratec sells one kinda like that but the clip is built into it. Its a Really nice mount. I think 4WP might sell the one he has.
 
You must log in or register to reply here.
Top Bottom