OFFLINE build

[berick1]

How'd you get the labels off the visors?

This is my first time owning a Jeep, so there's been a lot to digest in a short amount of time. I've had a lot of advice help from Templar, and by lurking in the forums ... so here goes ...

Purchased the end of June, 2015 -- 2015 Rubicon Unlimited, Sunset Orange. Automatic, max tow package (4:10 gearing)

Almost immediately, I started ordering parts. I started with:
EVO Enforcer Pro Stage 1 4" lift
Toyo OpenCountry R/T 37x13.5xR17 tires
Bushwacker flat style fender flares
B.A.D. Wheels Eklipse 17's. Love the DOT-approved wheels + beadlock. A little more hassle to get mounted, though.
PoisonSpyder brawler rockers
EVO C2 gussets
COAST 1310 front drive shaft
Superchips FlashCAL
AGM 2.0 King shock sliders to replace the stock EVO shock sliders
Hi-Lift jack & base

I'm still waiting on delivery for these ...
JCR dagger stubby bumper
JCR shield tire carrier
JCR front skid plate
JCR Crusader rear bumper

I also wanted to do most all of the work myself if possible. The lift was terrifying, especially after reading the cryptic instructions. Fortunately Templar and I had help from UTIAdam with that part.

Home from the dealer:
View attachment 162251View attachment 162252

Dashcam gets the honor of being the first thing installed:
View attachment 162253

Getting those annoying labels off the sun visors:
View attachment 162254

Tires arriving:
View attachment 162255

Prepping the coilovers. Coils going to the powdercoaters!
View attachment 162256View attachment 162257

Coming back from the powdercoaters!
View attachment 162265

B.A.D. Wheels have arrived!
View attachment 162260

Off to C&R Tire to get mounted and the back bead broken so I can insert the hardware afterwards
View attachment 162261

Painting the sacrificial rock rings and wheel hardware (center caps come chrome)
View attachment 162263View attachment 162262

Installing the Bushwacker fender flares:
View attachment 162271View attachment 162273

Test-fitting the brawler rockers
View attachment 162272

Finally, the LIFT! This was a 23hr marathon, doing both mine and Templar's lift at the same time with UTIAdam:
View attachment 162275View attachment 162276View attachment 162270View attachment 162259View attachment 162278

 

[Offline]

How'd you get the labels off the visors?

I used denatured alcohol on a shop towel. Lots of rubbing and patience. You work on a corner first to get it to peel up, and then very slowly peel it away while rubbing the shop towel into the backside between the adhesive surface and the visor. Eventually you can peel it all away and then clean up the visor of any leftover adhesive when you're done.

Took a good 15-20mins per visor to get them off.