LasVegasJK
New member
It was a 4x4 shop. No one else in town knew what a C gusset was.. I wasn't going to risk my ball joints due to an inexperienced welder.
Yeah, that's a legit concern.
It was a 4x4 shop. No one else in town knew what a C gusset was.. I wasn't going to risk my ball joints due to an inexperienced welder.
Nice good way to celebrate 4th of July
Nice! can't wait to get my doors and top off! Rubicon Run, 9 days to go!
Do you springs rest slightly on your C gussets?
They just slightly come into contact with them... I wouldn't necessarily say they rest on it. Did you go with Synergy Gussets?
Yeah "slightly contact" is a better way to describe it. No I got the EVOs just because they were cheaper. They fit perfectly and I don't think the spring contact would make any difference. It's so very slight. Slight enough that I could move it enough with my hand to get paint there.
I wish I would have went with Evos just due to the ease of install. My bill went up about a $100 bucks just because they had to pull the coil/shock/sway bar down and remove the coil
Damn! That sucks! Yeah all we had to do is jack it up, take the wheel/tire off so we had room to work, sit the upper in place hit it a couple times with a hammer for it to seat fully and that was it. The lowers went in perfectly with no hammer work.