My 07 JK build

[RockyJk]

Put on some drilled n slotted rotors



Check your brake pads this was after 10k miles


New rotors and brake pads :thumbup:

 

[Skid_Kid]

Check your brake pads this was after 10k miles
View attachment 42766

Wow! Brake much?

 

[RockyJk]

Wow! Brake much?

Lol! Ima blame esp on this one haha steering wheel was off center for a couple months and would kick on a lot pretty sure that caused the premature wear on my brake pads

 

[ShinDiggity]

Put on some drilled n slotted rotors

View attachment 42765

Check your brake pads this was after 10k miles
View attachment 42766

New rotors and brake pads :thumbup:
View attachment 42767

Now we can wheel without worrying about you slamming into the back of my Jeep!

 

[RockyJk]

Now we can wheel without worrying about you slamming into the back of my Jeep!

Lmao! Its safe again!!! :thumbup:

 

[RockyJk]

Met up with Moochie today and got me some parts from Smokey
Front Rubi locker, Chromoly axle shafts, and the ARB diff cover :thumbup:

Thanks again Moochie

Now need to get C-gussets and ball joints also need to figure out if I should save up some and re-gear/throw in a ARB locker in the rear or just get 4.10's for this and run it like that for a while

 

[RockyJk]

Evo C-gussets and control arm skids came in today


Also ordered ball joints today getting closer to building my front D44

 

[Bullwinckle]

Woot woot heck yea will be following along!


Ray

 

[RockyJk]

Woot woot heck yea will be following along!


Ray

Yea buddy!! Hopefully I'll do the swap an regear by the end of the month

 

[Bullwinckle]

Yea buddy!! Hopefully I'll do the swap an regear by the end of the month

Sweet get that extra power!!


Ray

 

[cap]

Now need to get C-gussets and ball joints also need to figure out if I should save up some and re-gear/throw in a ARB locker in the rear or just get 4.10's for this and run it like that for a while

Air lockers!:rock:

 

[RockyJk]

Air lockers!:rock:

Yup! Probably going to only be in the rear till the front rubi locker gives out :thumbup:

 

[RockyJk]

Sweet get that extra power!!


Ray

Lol which ain't much with the 3.8

 

[RockyJk]

Got the Evo c-gussets and skids welded on today just need to clean it up and paint the housing

Buddy charged me a Mcflurry and a Cheeseburger lol

 

[RockyJk]

Here's a shot of the gussets and skids welded up still gotta clean em up and paint

 

[RockyJk]

Ball joints came in today! :thumbup:

 

[Strike Force Zebra]

Need 4:10's? I have a set out of an 09 JKU with 6K on them. I'm in Utah but I'd let em go for a little bit of nothing!

 

[Canvas JK]

Build looks good. :thumb:

 

[RockyJk]

Need 4:10's? I have a set out of an 09 JKU with 6K on them. I'm in Utah but I'd let em go for a little bit of nothing!

Thanks for the offer but I'm going to just wait to get the rear locker and put in 5.13's

Build looks good. :thumb:

Thank you sir!

 

[RockyJk]

Thanks to Chris@offroadevolution hooked me up with some front seat covers put em on today but its too dark for a pic I'll post that tomorrow :thumbup: