They were definitely torqued to spec on the initial install. I followed the Dynatrac instructions exactly when mounting the knuckles, which is why this was such as surprise today. You may be right about the taper fit being off. Maybe the fit had a burr in it or something. IDKI’ve only seen this after install most likely not torqued to spec if it loosens back up the tapered fit may be off .
Possible it didn’t seat all the way the first time drive it for a bit and recheck the torque.They were definitely torqued to spec on the initial install. I followed the Dynatrac instructions exactly when mounting the knuckles, which is why this was such as surprise today. You may be right about the taper fit being off. Maybe the fit had a burr in it or something. IDK
Thanks, I’ll inspect it tomorrow and looks for signs of a crack.I recall at some point seeing someone here with a cracked knuckle around the lower ball joint. Probably worth checking.