zack.colo
New member
So I bought the JK used with some work on it, but the previous owner didn't mention any work to the front end. I was planning on installing some C GUSSETS but realized before I ordered the parts that they were already installed.
So next I plan to sleeve it, but figure it's probably a good idea to make sure there aren't any sleeves already installed. Pulled the axle shaft out to find there is some kind of RED boot-ish thing with a grease port at the end of axle port.
I can't figure out how to remove it.
I can't tell by looking inside if the diameter is significantly smaller.
If he had the sleeves welded in place they did a good job cleaning up because I can't see any spot welds on the outside of the axle tube.
My axle shaft is sitting on my bumper.
(I'll post pictures as soon as I figure out how to..)
Any ideas?
So next I plan to sleeve it, but figure it's probably a good idea to make sure there aren't any sleeves already installed. Pulled the axle shaft out to find there is some kind of RED boot-ish thing with a grease port at the end of axle port.
I can't figure out how to remove it.
I can't tell by looking inside if the diameter is significantly smaller.
If he had the sleeves welded in place they did a good job cleaning up because I can't see any spot welds on the outside of the axle tube.
My axle shaft is sitting on my bumper.
(I'll post pictures as soon as I figure out how to..)
Any ideas?