Gladys

The wind has quit blowing here so super busy. A little progress on the tank skid and third link mount. This is the rough draft but I think it’ll look similar to the finished product. The cross members in this JT are extremely thin. The JK platform is an anvil by comparison. The paddle up front will sit on top of the front x-member, then will come up from the bottom of the second x-member. Also Adam’s sent me a package.
Looks like progress.
 
Looks like progress.
Slowly getting there. I’ve had some time here and there, but no boxes checked for a while. I need to change that.
Was able to get the engine skid cut out and it fit the first time. Hoping to get it finalized this weekend, along with the tank skid. The lower control arm brackets also tie into the engine skid with the flange that is near the bottom, which is the same elevation as the bottom of the x-member. The window in the skid lines up with the drain plug and has a removable door.
 

Attachments

  • IMG_3056.jpeg
    IMG_3056.jpeg
    192.9 KB · Views: 6
  • IMG_3260.jpeg
    IMG_3260.jpeg
    206.5 KB · Views: 5
  • IMG_3259.jpeg
    IMG_3259.jpeg
    220 KB · Views: 6
  • IMG_3258.jpeg
    IMG_3258.jpeg
    168.9 KB · Views: 6
  • IMG_3261.jpeg
    IMG_3261.jpeg
    263.1 KB · Views: 6
Top Bottom