OverlanderJK
Resident Smartass
Sounds like a good plan. Thanks! Mine doesn't look that bad yet just a light splattering so far must be the early stages.
You'll hear it clicking before it goes.
Sounds like a good plan. Thanks! Mine doesn't look that bad yet just a light splattering so far must be the early stages.
DS install write-up on Project-JK. For 1310 but same process for others.
http://project-jk.com/jeep-jk-write...-front-1310-drive-shaft-installation-write-up
Air wrench is helpful, especially for the pinion nut, but not necessary for the rest (can't get it into a lot of tight spaces).
Here is a little tip photo:
View attachment 144053
:thumb:
Beautiful! It looks like I am going to have some fun this weekend! :clap2:
Pay attention to the install process/instructions and in particular the torque for the pinion nut. Needs to be enough but you don't want to over do it and damage something there. Have a fun weekend! :yup: