Evo Protek System

Just got the rubber isolator nuts off. Was not easy. Jacking up the trany now,scary. I have jacked up about 1/2 inch,but not much separation. How high can you jack it?
 
Last edited:
I installed these last week, where do the two large washers go? Never found that part out ,

Sent from my VS980 4G using WAYALIFE mobile app
 
Wondering about those washers also. What about the t case?

Sent from my SM-N900W8 using WAYALIFE mobile app
 
xkid said:
Wondering about those washers also. What about the t case?

Sent from my SM-N900W8 using WAYALIFE mobile app
Click to expand...

I didn't use the large washers :idontknow: your stock t case skid is all you need it bolts back down onto the cross member skid :yup:
 
Panda said:
I didn't use the large washers :idontknow: your stock t case skid is all you need it bolts back down onto the cross member skid :yup:
Click to expand...

Me either, i think they might go on top of the transmission mount bolts. Idk... Left mine out too.

Sent from my VS980 4G using WAYALIFE mobile app
 
JK_b/c_yolo said:
Yeah, i read that a few times before i did the install. Maybe we have the deluxe kit.
Btw, does your center skid touch the rear of the transmission pan? I have an auto tranny.

Sent from my VS980 4G using WAYALIFE mobile app
Click to expand...

No it don't touch, I have auto trans also, you did put it on top of the trans mount right? You only jack the trans up to get it in place, then it bolts to the trans mount on top, not in between the trans & crossmember just to be clear because I was a little confused on that part at first
 
It goes on top of the rubber isolator. But how much can you lift that transfer case? and is it safe?
 
Panda said:
No it don't touch, I have auto trans also, you did put it on top of the trans mount right? You only jack the trans up to get it in place, then it bolts to the trans mount on top, not in between the trans & crossmember just to be clear because I was a little confused on that part at first
Click to expand...

Yes, i wade confused to on. That part, that's what i did, I'm going to snap some pictures.

Sent from my VS980 4G using WAYALIFE mobile app
 
xkid said:
It goes on top of the rubber isolator. But how much can you lift that transfer case? and is it safe?
Click to expand...

You can lift the transfer case till it hits the floor of your jeep, it'll just be hard to get the trans mount studs back in place, you only need to lift 1/2 inch to get the trans skid in place
 
Mine must have been catching on something. I was past a 1/2 inch that's for sure.

Sent from my SM-N900W8 using WAYALIFE mobile app
 
Need help!
When installing the protek system. The tranny skid gets sandwiched here where the arrow is pointing???

I have jacked up the t case that's it's starting contact the floor. And there is still no room to get the tranny skid in-between the rubber mount and the tranny mounting plate

Please help!
ImageUploadedByWAYALIFE1418095217.723681.jpg
 
You must log in or register to reply here.
Top Bottom