Angry Aussie
New member
Hey guys, I just installed the evo manual sway bar disconnect and now my sway bar light is flashing. Is there a way to turn it off? What have you guys done about this? Or am I the only one it's happened to.
Evo manual sway bar disconnect
- Thread starter Angry Aussie
- Start date
j3rs3yd3vil
New member
I've heard the aev pro cal remedies that problem, I'm not quite sure otherwise though, you may be able to take it to the dealership and have them disable the light.
Angry Aussie
New member
Ok cool thank you
cozdude
Guy with a Red 2-Door
The latter and it just needs to be snug
JAGS
Hooked
Good to know. This may be my only solution as it appears my problem is not the motor. I may try one more motor swap...not holding my breathe.
Possibly a bad harness, bad switch or bad mechanism.
piginajeep
The Original Smartass
You can wire it direct to a switch. Not a straight forward job but it can be done. If you are going with the knob, can I have the motor ??
More than likely it's the board
JAGS
Hooked
You know damn well I'm not fucking around with any wiring. Lol. Once I figure things out I'll let you know. [emoji106]
Want mine? My connections broke but I'm sure the board still works. I'm traveling until Thursday. I can shoot you a picture of it then
piginajeep
The Original Smartass
Yup! Send me a message when you can !!
Skid_Kid
New member
Such harsh emotions when it come to wiring.......
JAGS
Hooked
I just know my limitations, which are fairly low for this type of stuff. [emoji6]
Sharkey
Word Ninja
piginajeep
The Original Smartass
He can get the key into the ignition. What more do you want?
That's a normal JK owner...
JKbrick
Active Member
He can get the key into the ignition. What more do you want?
Push button start?
