EVO 1/4 Pounder Front Bumper

BruceyZ06

Member
I love my EVO quarter pounder bumper on my JT. I recently acquired a JL. Wanting to run the same bumper. However, on my JT I installed a front Anti Rock sway bar. On the Jeep JL I'm keeping the facotry sway bar. Will this Sway bar flip kit work with this EVO bumper?


Thanks everyone!
 
I just did what it says in the EVO instructions on page 10...

https://www.dealer.evomfg.com/technical-docs/EVO-3057.pdf

Basically:
Remove the mounting bolt
Rotate the sway bar motor
Use a 1/2" drill bit marked with tape to only drill 1/2" deep
drill out the other hole
reuse the factory bolt into the hole you altered.

Been working fine for four years and didn't cost a dime.
Wow, I feel slow. Guess I should've read the instructions hahahaha.

Thanks!
 
Top Bottom