jku612
New member
Simple 6” tall platform
This is a platform made from a 1/2” plywood from Lowe’s. The supports are 6” tall. They secure front and rear to the factory tie down locations using the factory screws and 2” angle brackets. I used the cargo mat from my old KK to cover it. A sheet of cardboard helped with making the template. I place heavy items over the supports, everything else goes towards the center. Some of my recovery gear goes in an old Blackhawk case I had. It is accessible from the gate or the rear seat when needed. My on board 12v water will be going in the slot on the left where my camp chairs are now. I’ll probably bed liner it when I’m satisfied that is finished.
This is a platform made from a 1/2” plywood from Lowe’s. The supports are 6” tall. They secure front and rear to the factory tie down locations using the factory screws and 2” angle brackets. I used the cargo mat from my old KK to cover it. A sheet of cardboard helped with making the template. I place heavy items over the supports, everything else goes towards the center. Some of my recovery gear goes in an old Blackhawk case I had. It is accessible from the gate or the rear seat when needed. My on board 12v water will be going in the slot on the left where my camp chairs are now. I’ll probably bed liner it when I’m satisfied that is finished.
