Cut Fenders and Pinch seams
- Thread starter FastZach
- Start date
pvanweelden
New member
Angle grinder with cut wheel disc, just need to get rid of the point basically, paint afterwards.
Sent from my SM-N900V using WAYALIFE mobile app
Sent from my SM-N900V using WAYALIFE mobile app
I took 1 inch off the bottom and two inches up to make my line to cut. I used a sawsall to cut mine. If you go to you tube you can search for Jk pinch seam trim. I used JB Weld to fill the void. I will see about taking some pic later. I am also running 35's so you may have to adjust your diminsions a little to fit the 37's.
Here is a member asking the same question as a reference.
http://wayalife.com/showthread.php?6520-pinch-seam-trim
Here is a member asking the same question as a reference.
http://wayalife.com/showthread.php?6520-pinch-seam-trim
Last edited:
Nice set of sliders, where did you get those?
SJ21XDC
New member
So I have 3.5" RK lift on my JKUR and just put 37" Nitto TG and also cut the fenders. When the rear tires travel up they hit the pinch seams in the back.. How can i cut these and how much can I cut off?? Pictures are greatly appreciated. Thanks[/QUOTE]
Angle grinder with cut off wheel or sawzall both work. Just mark, cut & fill with JB weld. Here's where I cut mine.
Angle grinder with cut off wheel or sawzall both work. Just mark, cut & fill with JB weld. Here's where I cut mine.