BrankZ thread

I had a thread about this but for some reason can't find it


Let's do this again


Fail paint job let's fix it
ImageUploadedByWAYALIFE1426615337.277040.jpg

ImageUploadedByWAYALIFE1426615356.706520.jpg
ImageUploadedByWAYALIFE1426615367.804290.jpg
ImageUploadedByWAYALIFE1426615381.827148.jpg
ImageUploadedByWAYALIFE1426615396.082830.jpg
Still waiting in the other tail light before painting
And I need to give them a nice bath of engine degreaser and water than painting them 👍
 
Long proses but is done, let's try painting this again View attachment 131377

Since you touched the bare metal you have left the oils from you hands on it and will not hold paint very well. Run water over it and if you get beading then it is not clean. If the water runs off break free then it is ready for paint. This time do no touch the bare metal with out clean gloves.
 
Since you touched the bare metal you have left the oils from you hands on it and will not hold paint very well. Run water over it and if you get beading then it is not clean. If the water runs off break free then it is ready for paint. This time do no touch the bare metal with out clean gloves.

Yup...... After that pic I use engine degreaser to remove pain stripper after that I wash it with water than I use this with gloves ImageUploadedByWAYALIFE1426620796.951569.jpg

Thanks for the hands up by the way
 
Top Bottom