Working on my mirrors, what you think?
View attachment 56510
View attachment 56511
View attachment 56512
Any suggestions are welcome
Just spoke with the Nigerian Safety Officer and they stated your mirrors are too low and need to be higher.
BrankZ thread
- Thread starter Brankz
- Start date
Just spoke with the Nigerian Safety Officer and they stated your mirrors are too low and need to be higher.
Atch
New member
Working on my mirrors, what you think?
View attachment 56510
View attachment 56511
View attachment 56512
Any suggestions are welcome
Try putting it in the passenger lower hinge. I find it is easier to use from that angle.
Brankz
New member
Just spoke with the Nigerian Safety Officer and they stated your mirrors are too low and need to be higher.
Thanks I will try to think something different. Lol Nigerians, they did not send me the pic :/
Brankz
New member
I need your help wayalifers please!!!!
So I just noticed that my jeep is trowing lots of heat, it's like super hot, I don't what's up, no check engine light and the temperature is a lil less than half, so I really don't know what's going on, it's that ok or I have to check in to it?
So I just noticed that my jeep is trowing lots of heat, it's like super hot, I don't what's up, no check engine light and the temperature is a lil less than half, so I really don't know what's going on, it's that ok or I have to check in to it?
Tigrcky
New member
what temp is it reading? i need a number anything around 180-210 is normal
cozdude
Guy with a Red 2-Door
It's normal. As long as it's below the middle line your good. If your worried that much about it get the PS hood louvre or some other type of hood vent
Sent from my iPhone
Brankz
New member
Brankz
New member
Thanks. I got worried cause i noticed lots of heat from the engine, and when I checked it was HOT HOT HOT! Lol
Never noticed that much heat.
Tigrcky
New member
your exhaust manifolds will normally run up to 400-600 degrees so go and run your engine hard and get it all hot then grab one with your hands :yup:
Brankz
New member
Hahahahahahah after you brotha.
See that is where you put your canned ravioli's before you start the trail. when luch comes you have a hot lunch on a cold day. Hey it works for me.
Brankz
New member
Lol I saw that in top gear USA
Strength is the main difference. Many other technical differences, but the main differences are streangth
Read this
http://www.fourwheeler.com/how-to/154-0708-weakest-to-strongest-axles/
The main difference is the size and the amount of weight they can hold. A D60 and D80 are also referred to as 1 ton axels. Depending on what version fo D44 you get will determine the wall thickness of the axel tubes. In a nutshell the larger the number on the axel the stronger it is usually.
Good Question Brankz,
R/
Will
Brankz
New member
Thanks for the info, I always see stuff about d44 & d60.
Moochie
Active Member
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
Brankz
New member
Yea that's 100% true.