Birth of Phoenix
- Thread starter BABOOZLE
- Start date
TrailHunter
Hooked
Looks Sharp!
BABOOZLE
Caught the Bug
BABOOZLE
Caught the Bug
Elroy231
Active Member
Elroy231
Active Member
Sorry, I slaughtered that. Your rig is looking great. That spare tire carrier came out awesome. [emoji106]
Sent from my SM-G965U using WAYALIFE mobile app
wjtstudios
Hooked
Turned out great!
2015 JKUR AEV JK350
1985 CJ8 Scrambler
2015 JKUR AEV JK350
1985 CJ8 Scrambler
BABOOZLE
Caught the Bug
I had to read it a couple times. [emoji23] Thanks!
Thanks! [emoji4]
Sent from my iPhone using WAYALIFE mobile app
BABOOZLE
Caught the Bug
New license plate light by Off-road Only. Old Poison Spyder one broke. But they use the same connectors so this one plugged right in. Easy day. 
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app
Mattznpc
Member
Jeep looks great, that finished it off nicely,.....well for now haha
Sent from my SM-G965U using WAYALIFE mobile app
Sent from my SM-G965U using WAYALIFE mobile app
BABOOZLE
Caught the Bug
BABOOZLE
Caught the Bug
Finally got the Jeep out and tested the new long arm. Everything went really well. I can notice the difference with the tire climbing a rock. Much smoother and not forced. I disconnected my Antirock because I wanted as much flex as possible. If I disconnect, then I need a little more bump. Limit straps are needed. But I want to wait and see if I’m going COs or not. An aluminum tie rod might be in the future as well.
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app
wjtstudios
Hooked
The LAs are definitely worth the headache. Great flex for sure!
2015 JKUR AEV JK350
1985 CJ8 Scrambler
2015 JKUR AEV JK350
1985 CJ8 Scrambler
Elroy231
Active Member
Bullwinckle
Hooked
Looking great! [emoji106]
BABOOZLE
Caught the Bug
BABOOZLE
Caught the Bug
Knocked out some things that needed to be done. Replaced the axle seals in the D60. The carrier was fun pulling out and putting back in. The old seals came out with the shafts which is a little concerning.
Also I finally swapped the my T Case out for a Rubicon case. It sat in my garage for about 6 months. The top two bolts suck. I can lower my crossmember because my lower links bolt to it. Finally figured out a solution with a crows foot and going back to front. Didn’t work for the other one so I cut my wrench in half and used a ratchet strap to break it loose.
Sent from my iPhone using WAYALIFE mobile app
Also I finally swapped the my T Case out for a Rubicon case. It sat in my garage for about 6 months. The top two bolts suck. I can lower my crossmember because my lower links bolt to it. Finally figured out a solution with a crows foot and going back to front. Didn’t work for the other one so I cut my wrench in half and used a ratchet strap to break it loose.
Sent from my iPhone using WAYALIFE mobile app
Cousin Clyde
Hooked
Nice maneuvering with the wrench situation. That new t case looks so fresh!
Sent from my iPhone using WAYALIFE
Sent from my iPhone using WAYALIFE