Search results

teaser pic Haven't been posting on any forums and probably done with them. So if u wanna follow the jeep build... find me on IG Sent from my iPhone using WAYALIFE mobile app

Ok heres an actual teaser pic haha. I really didn't wanna make it stick over the top of the windshield at all but had to a little for head room. (Being that I'm 6+ feet tall) While looking at the front it is barely noticeable that the cage sticks over a little. Sent from my iPhone using...

Cage done Sent from my iPhone using WAYALIFE mobile app

Both seats are fully mounted time to get serious on the cage. Sorry for the lack of in progress pics was trying to get it done. Sent from my iPhone using WAYALIFE mobile app

Got to work mounting the seats. Made some brackets out of 1/4" that will be directed welded to the main lower tubes of the cage. Still need some more tube run along the floor to mount the front of the seats.

Just wait, you will see how beef it's going to be. The entire cage and everything else is going to be welded to it. U never seen a backhalf tube jeep buggy? It will something look like this

Making some what steady progress.

My Christmas morning was spent in the shop and got the main rear frame section completely welded into place. Gonna clean up and grind down the extra overhang of the frame plates eventually,

Got some more knocked out this morning. Started bending my main piece of frame. (It will sit a little higher and flatter than in the pic) Then I cleaned up and grinded all the factory control arm mounts off. Then made plates that with have a hole cut in them to slide over the tube and weld to...

Keep making steady progress. All 4 amrs are tacked together and all mounts are tacked onto the axle. Put the tire on to start planning the backhalf/cage.

Worked on the jeep some more last night. I got my pinion angle where i think I needs to be. Then i tacked my upper arms together and upper mounts to the axle. To accomplice the full bump Im looking for, I had to cut the floor for clearance of my upper control arms.

Finally started working on the jeep again. Dropped the stock 44 and finally chopped the frame. Next i put the axle in place and started to measure for wheelbase. Decided I'm going for around 111". Made pvc mock up links then cut metal and have upper links ready to weld. Gonna get the lowers cut...

Teaser

Big progress has been made. Next step is chopping frame and building links. Then roll cage/back half

Making very small progress but atleast it is something.

In the front, I cut the rubi rail down a little and the body. Also cut the metal fender support off. So did not add any bump stop up front. In the rear, i cut the fender well out all the way around and it still wasn't enough. So I made some bumps out of scrap. Don't remember how tall they were...

Worked on the jeep some more and finished cutting out the factory crossmember behind the tcase. This is where my lower link crossmember is gonna be. Getting close to getting my link mount tac-ed on and then onto cutting the frame and building cage

Finally the atlas 4 speed fits and is bolted into place

Pulled the console and seats to prep for install atlas shifters. Started cutting the floor to fit the atlas. But didn't take any pictures.

Flat belly for this pos