Search results

So I got my bump stop issue resolve. I took the 4" aluminum synergy bump stops to a friends machine shop and shortened them to 3.5" and bore out the hole for a .5" bolt and bore out the top to have the cap head counter sunk. Then I went to the hardware store and found the bolts. Total cost $1...

Pr 44 I finally received my PR44 from Trail Jeeps!! can't wait to get it installed! My living room is starting to fell cramped! i will probably post this question on another relevant thread, but what is everybody using for bumpstops on the PR44? i had bought some 4" synergy bumpstops to...

I got it in through the hole that is used for the window wash line for rear window. I had to modify the gasket a little

Received my JE Reel 1350 rear drive shaft today Adding it to my parts pile I also received my new unit bearings, I figured since I was replacing the housing and ball joints I would go ahead and get new bearings as well!

this is what you have...

I am starting to beef up my jeep and am currently waiting on some parts to come in in preparation for a trip to the rubicon hopefully this year with my dad, a sport cage would be a great addition to the build sheet!

vote for #4

Steer Smarts Yeti Tie Rod just received my steer smarts yeti tie rod, this thing is massive. i think it will hold upto to PSC kit. Parts are starting to accumulate again!

The exhaust loop on the drivers side

Got around to installing my Switch Pro this morning, install went smooth and easy. I will say that the instructions are very easy to follow and not confusing at all! I even rerouted my winch wiring. As you can see the mosfet unit takes up very little space I routed the wires that go into...

Shouldn't be to hard.

I did that! Trim your fenders- flat fender mod, trim your front and rear pinch seams about 1.5"-2", install 2" bump stop extensions in the rear, rear out steering stops about 1/4", stubby your front bumper and trim the rear bumper or remove all together. Probably could have used a 1" bump stop...

Yup, I had to grind the top outer edges of the frame horns so that the top front bolt on the stinger plate could be used

Time for an update. Since post #47 I re-sprayed the cut fenders with bed liner, I broke some of the clips and bought some off of amazon. The front passenger side fender only had Amazon fender clips and flew away on the highway, thankfully it didn't hit anybody, I turned around to pick it up but...

Boom

I could never see that being an issue if you plan your line over an obstacle properly. The obstacle will have to be very odd to reach into grill

Ran into a hiccup while installing the stinger. I had the bumper and stinger mounted with the eight hex bolts snug. Then I drilled the top rear outside bolt holes for the stinger. Then I installed those bolts to clamp down the stinger to the top of the bumper. I then proceeded to drill the...

My 3/8" drill bit just took a dump!

What's this??

I can only assume that the inserts are the same as the slabs, these are the ones you need: I found them at my local fastenal, 4 for $13. Not cheap. As far as the bolts, I have a whole bunch of the black ones that came originally with the wheels, I can ship on your dime, it won't be all of...