Used unwanted Dana 30 stub shafts

ridg3runner

ridg3runner

-
Doesnt matter what condition the yoke side is in, it will be deleted anyway. Just need the splines and threads undamaged. I am planning an experimental trailer axle build with my old unit bearings but accidentally sent my stubs to the dump a few months ago. Left coast only please.

We are Jeep..Resistance is futile..
 
Last edited:
ridg3runner said:
Doesnt matter what condition the yoke side is in, it will be deleted anyway. Just need the splines and threads undamaged. I am planning an experimental trailer axle build with my old unit bearings but accidentally sent my stubs to the dump a few months ago. Left coast only please.

We are Jeep..Resistance is futile..
Click to expand...

wish i had the 3 i trashed... sorry bud here is a bump for you!! :beer:
 
Didn't even think that I would need them until I found an article online of someone else trying it:banghead:

We are Jeep..Resistance is futile..
 
Tigrcky said:
if you want a good trailer axle i know where a good dana 70 is...:yup:
Click to expand...

Thats the route I'm going on my trailer! Any 1 ton full floater. Probably another sterling so I can have spare shafts for my rear.


My ride- 2001 power wheel, 11" plastic tires, upgraded battery, boat sides, custom bumpers, tow hooks, new paint.
 
David1tontj said:
Thats the route I'm going on my trailer! Any 1 ton full floater. Probably another sterling so I can have spare shafts for my rear.


My ride- 2001 power wheel, 11" plastic tires, upgraded battery, boat sides, custom bumpers, tow hooks, new paint.
Click to expand...

well the dana 70 i have is the dually HD with 4 inch tubes
 
You must log in or register to reply here.
Top Bottom