Wheel hub re-assembly

[Cousin Clyde]

Anyone ever put a little bit of anti seize around the mating surface before putting it back into the knuckle?


Sent from my iPhone using WAYALIFE

 

[Cjxjjk]

You bet! I have done it with every Jeep I have owned. The next guy will thank you, especially if you happen to be the next guy that goes back in.

 

[nbunga]

Yep. Every time. Much easier the next time you take it off. And there will be a next time.

 

[WJCO]

Anyone ever put a little bit of anti seize around the mating surface before putting it back into the knuckle?View attachment 342045

Yes. Every time.

 

[OverlanderJK]

I never have.


Sent from my iPhone using WAYALIFE

 

[Bierpower]

Anyone ever put a little bit of anti seize around the mating surface before putting it back into the knuckle?View attachment 342045


Sent from my iPhone using WAYALIFE

For sure. They are a pain to pull off on the trail to remove axle shafts after blowing a front ring gear when they are all rusty. Ask me how I know.

Sent from my Pixel 2 XL using WAYALIFE mobile app

 

[WJCO]

For sure. They are a pain to pull off on the trail to remove axle shafts after blowing a front ring gear when they are all rusty. Ask me how I know.

Seems to have the most rust as opposed to any other part around it during removal.

 

[Snboarder113]

I never have.


Sent from my iPhone using WAYALIFE

You dont live somewhere they salt roads.

 

[cozdude]

As mentioned by others, every, fucking, time. I usually take a wire wheel to the inside of the knuckle as well to remove any dirt and rust that has built up in there as well as extra measure.

 

[Cousin Clyde]

Word! Thanks guys. Good tips[emoji106]


Sent from my iPhone using WAYALIFE