Ultimate dana60 PSC cylinder assist

[ice.v8]

Hello guys, i have a psc 1.5 x 6.75 stroke cylinder assist on the stock front rubicon axle, thinking to upgrade to an Ultimate dana60, will the 6.75 stroke be enough or the 60 needs the 8 stroke cylinder assist ?
Thanks

 

[RESURECTIONJK]

Hello guys, i have a psc 1.5 x 6.75 stroke cylinder assist on the stock front rubicon axle, thinking to upgrade to an Ultimate dana60, will the 6.75 stroke be enough or the 60 needs the 8 stroke cylinder assist ?
Thanks

You will need need the longer 8” cylinder.

 

[Bizcuit]

You will need need the longer 8” cylinder.

Can you get the UD in wide?

 

[RESURECTIONJK]

Can you get the UD in wide?

To my knowledge no. They are wider than a stock JK44 but not quite what I would consider to be full width.

 

[ice.v8]

You will need need the longer 8” cylinder.

Thanks, so the UD60 has more steering stroke then the factory axle ?

 

[RESURECTIONJK]

Thanks, so the UD60 has more steering stroke then the factory axle ?

Yes that is correct. Not by a lot but enough that the 6.5” Ram will bottom out before the steering of the axle. The 8” is a touch long for the UD60 but, that can be managed with setup.