SLO
Member
I am updating my spares kit and tool kit for Dana 60’s and I want to make sure I’m not missing anything.
The D60’s are Fusion King Pins with Yukon hubs. I know I’ll need hex keys/bits to service the hubs and long snap ring pliers (Knipex 4911A3) for the external snap ring. Are there any specialty sockets I need to pull a shaft? Anything else i should add to my kit that’s specific to Dana 60’s (obviously, I can see what’s on the outside...I’m referring to things that are internal to be able to do a trail repair).
As far as spares, I’ll swap out my u-joints and I’m not planning to carry a spare axle shaft. I believe the u-joints are SPL55-3X, correct? What about the u-joints for Adams 1350 drive shafts? Anything else I’m missing?
The D60’s are Fusion King Pins with Yukon hubs. I know I’ll need hex keys/bits to service the hubs and long snap ring pliers (Knipex 4911A3) for the external snap ring. Are there any specialty sockets I need to pull a shaft? Anything else i should add to my kit that’s specific to Dana 60’s (obviously, I can see what’s on the outside...I’m referring to things that are internal to be able to do a trail repair).
As far as spares, I’ll swap out my u-joints and I’m not planning to carry a spare axle shaft. I believe the u-joints are SPL55-3X, correct? What about the u-joints for Adams 1350 drive shafts? Anything else I’m missing?
