Running without axle shaft.

xflstl

xflstl

New member
Can driving without a front axle shaft or stub shaft cause cruise control and remote start to not function... Trying to figure out if the wheel sensor can tell if there is no shaft on the front?

Both cruise and remote start functioned properly, until I broke a u-joint smucked up the stub shaft and removed them so I could drive home.


Any unit bearing masters out there that can tell for sure if this problem would be related or pure chance?
 
Running without a shaft will not effect your cruise control or otherwise. Your speed sensor reads a tone ring located on your unit bearing. If you mucked up your stub shaft, it may have damaged it.
 
wayoflife said:
Running without a shaft will not effect your cruise control or otherwise. Your speed sensor reads a tone ring located on your unit bearing. If you mucked up your stub shaft, it may have damaged it.
Click to expand...

No visible damage to the unit bearing, and the stub shaft well the damage to it was simply to the u-joint (ear) area. Getting it hooked up to a scan tool tomorrow, guess I will wait and see what it says. :)
 
It might be a bad wheel speed sensor (the piece that has the magnet that reads the tone ring). It could be something as simple as the sensor's tolerance (distance) from the tone ring was changed.
 
GCM 2 said:
It might be a bad wheel speed sensor (the piece that has the magnet that reads the tone ring). It could be something as simple as the sensor's tolerance (distance) from the tone ring was changed.
Click to expand...

Ya I was thinking that as well, maybe it didn't get put back in correct / tight enough or something...
 
Go figure clock spring needs replaced, and the hood sensor was loose......

Problems solved.

Sent from my DROID RAZR using Tapatalk 2
 
You must log in or register to reply here.
Top Bottom