aermotor
Member
Currently running 1.5" wheel spacers and a PR44 front and looking to the future for a semi-float PR60 rear. I would think it better to avoid wheel spacers however I can and to minimize stress on the rear flanges, so would it be better to get the extra width PR60 and then only have to run the wheel spacers up front? Or are there other options? Or do I just get the standard width and run spacers?
Currently have non-beadlock wheels with about 4.5" backspacing but would like to get some KMC Machete down the line a bit perhaps, so not sure if that effects this decision or not. Currently running 37s and will stay with these. I know I don't need the PR60, but just gathering info.
Currently have non-beadlock wheels with about 4.5" backspacing but would like to get some KMC Machete down the line a bit perhaps, so not sure if that effects this decision or not. Currently running 37s and will stay with these. I know I don't need the PR60, but just gathering info.
Last edited: