For those of you with the Lux kits, was the 8pc enough or did you supplement it with additional?
I was thinking 1 in each fender well, 1 on each side and 1 front and rear with the sides / front / rear being kind of centered.
Thanks!
Here are some shots of the 8pc kit on my buddies JKUR. One in each fender and two on each side tucked under the sliders... he is planning on adding 2 more tucked up under the front bumper because his front D60 and 40’s create quite a bit of shadowing.
Here are some shots of the 8pc kit on my buddies JKUR. One in each fender and two on each side tucked under the sliders... he is planning on adding 2 more tucked up under the front bumper because his front D60 and 40’s create quite a bit of shadowing.
It’s close to full coverage with just the 8 lights.
View attachment 359200
But to Ddays point, two more lights up in the fender might complete the light spread
2015 JKUR AEV JK350
1985 CJ8 Scrambler
That looks pretty dang even for light coverage. Can you post a side shot if you have one? I’m thinking I might want to add 4 more to the 8 sitting on the garage floor.
I was thinking the 4 pack would be enough now I'm leaning more towards the 8...haha.
Sent from my SM-G973U using WAYALIFE mobile app
Sure, here’s the rest of the way around View attachment 359205
View attachment 359206
2015 JKUR AEV JK350
1985 CJ8 Scrambler
Thanks dude. That looks great.
Sure, here’s the rest of the way around View attachment 359205
View attachment 359206
2015 JKUR AEV JK350
1985 CJ8 Scrambler
Looks good! Did you do 2 in the front / back and on each side and skip the wheel wells?
Looks good! Did you do 2 in the front / back and on each side and skip the wheel wells?
Yes, you can see the hot spots in the jeep where they are
2015 JKUR AEV JK350
1985 CJ8 Scrambler
That's it, you need to see in front and back of each tire for the best coverage.
If you only have four, and go in the wheel wells, you will have a lot of shadows, but still be far better than no light.
Went with 12pc, got an 8pc with 20' and 4pc with 10' wires. I figure I will do the 2/2/2/2 for the front / rear and sides and then put one in each fender well. Should get pretty good coverage that way!
Nice. Post up a pic when you get them installed.