JKS adjustable front track bar

bouche03

bouche03

Member
Hey guys-hoping someone out there in WOF land can help a brother out. My factory track bar bushings are shot and was looking to get JKS adjustable front TB. I picked this one specifically because I need the replacement to have a narrow neck at the axle end, ala the JKS due, to the Synergy raised mount on my PR44. I was wondering if someone with this track bar would be so kind as to measure the length on it. I need it to be able to adjust down to 32.5", which is basically factory length. I search everywhere I could on the interwebs and the JKS website, and their installation manual/spec sheet doesn't even have the length listed.

Thank you so much in advance!!

Nick
 
I bet it will be fine and adjust close to stock... I was going to buy the JKS but I went with the Synergy... I measured it before leaving the store as I was uncertain as well if it would go short enough... on the JKS website it says replaces OE so I’m sure it will work.
 
You must log in or register to reply here.
Top Bottom