Jeep control arm skid plates

[gtony12]

Question, when I install and weld in my CONTROL ARM SKID PLATES do I need to remove the Control Arms/unbolt and hang down. Or can I weld in place. Wasn't sure if the bushing may get to hot? :thinking:
Anyone done these and have any suggestions.:idontknow:

 

[wayoflife]

While it may not be necessary, if it were me, I'd pull your control arms.

 

[DA RUNT]

Unbolted the control arms when I did mine. Better safe than sorry :yup:

 

[gtony12]

I have the fronts that are weld on and was going to get rears, I found some bolt on's what do you all think are these any good or should I get the weld on ones?:idontknow:

 

[OverlanderJK]

I have the fronts that are weld on and was going to get rears, I found some bolt on's what do you all think are these any good or should I get the weld on ones?:idontknow:

Bolt on's as in EVO rockstar skids? Yes those are good. They can be weld on or bolt on.

 

[cozdude]

I have the fronts that are weld on and was going to get rears, I found some bolt on's what do you all think are these any good or should I get the weld on ones?:idontknow:

you can get the bolt ons and if you dont like the strength then im sure you could have them welded on after

edit- evo rock stars are bolt on and strong enough as overlander mentioned