Inner fender chop

[14JK-U]

I cut up the stockers today and tomorrow I'll be finishing up the inner liners. One issue I ran into: when I pulled out the push tabs a lot of them were hard and broke. Anyone else have this issue? Did you have to get new tabs or is there another solution for those mounting tabs

Sent from my SAMSUNG-SM-J327AZ using WAYALIFE mobile app

 

[BABOOZLE]

Did you pull the fenders off before cutting or did you leave them on? I don't remember what the tabs look like but Autozone or any parts store usually has a large selection plastic rivets and tabs. Do you have a picture?

 

[14JK-U]

Pulled them off, after a few years of trails it was a good excuse to get mud and leaves out of all the corners

Sent from my SAMSUNG-SM-J327AZ using WAYALIFE mobile app

 

[Eroc147]

I got these from amazon and keep them in the jeep for when(not if) I pull a fender off on the trail. Wayyy cheaper than autozone or the dealer. JEEP WRANGLER - FENDER FLARE - ROCKER MOULDING - BUMPER SHIELD , 6501559,(6506007-AA) 68039280-AA, 6030441, ON-HAND ASSORTMENT , by POPULAR AUTO PARTS https://www.amazon.com/dp/B01GES5OYS/ref=cm_sw_r_cp_api_P7FjAbHDMBZJE


Sent from my iPhone using WAYALIFE mobile app

 

[jeeeep]

you can also get them on Clipsandfasteners for a bit cheaper, same clips

https://www.amazon.com/Moulding-680...1512443752&sr=1-1-catcorr&keywords=68039280AA