Coast drive shaft install

[just-lift-it]

Hey guys I installed my coast front shaft tonight but think I may have missed a step!

Is this O ring needed on the new tcase yoke? Didn't notice it until after I was done! Not a big deal to pull the shaft and install it though

Thanks

Sent from my iPhone using Tapatalk

 

[jeeeep]

I used in in mine - also a Coast

 

[Jkjon]

I didn't notice it until after I was done as well. I just used some RTV on the splines before installing the yoke.

 

[wayoflife]

I didn't notice it until after I was done as well. I just used some RTV on the splines before installing the yoke.

What he said ^^^ There is no need to reuse the o-ring, just apply some RTV to the base of the output shaft nut.

 

[just-lift-it]

So do I need to pull the shaft and everything and rtv it? Or just rock it if it isn't leaking and keep an eye on it? Gonna be a bitch to get the yoke off with red lock tight


Sent from my iPhone using Tapatalk

 

[just-lift-it]

Should maybe update those write ups Eddie mention the stupid o ring haha


Sent from my iPhone using Tapatalk

 

[Jkjon]

My rear coast shaft started leaking through the splines straight away without RTV. (started slinging all over my gas tank skid) I'm guessing its fine if it isn't leaking but I would keep an eye on it.

 

[wayoflife]

You'll probably be okay. I would just leave well enough alone unless it starts to leak but, being that it's your front shaft, I doubt that it will.

 

[wayoflife]

Should maybe update those write ups Eddie mention the stupid o ring haha

LOL!! Sorry about that. I probably should update a few of my older write-ups. :crazyeyes:

 

[just-lift-it]

Thanks everyone!!! I'll just check it every day for a bit see if it leaks!


Sent from my iPhone using Tapatalk