Back up light???

[Jake Wilson]

Hey so I have the EVO tire carrier with EVO Skins as well as the rear fascia. I was planning on using my rigid industries spot light on top of the fascia. However, it hits my tail door?! Any good ideas how I can fix this?

I was gonna use one of the holes on the top to mount the back up light.

 

[LasVegasJK]

You'll need a single row led if you want to mount them there.

 

[dcbjk]

I think that Hinrich can help you in that single row led idea it's on his build thread I believe
Here is a example from his build thread

 

[Jake Wilson]

You'll need a single row led if you want to mount them there.

I see. Is there anyway I can utilize what I already have?

 

[Speeddmn]

Is there a way to do them upside down on the bottm of the tire carrier? Otherwise maybe cut holes in the facia and install them in it...

 

[P1TBU11]

Or sell the fascia to me and mount it to the rail

 

[JES]

I see. Is there anyway I can utilize what I already have?

You could always mount them on the tire carrier as an option.

 

[zimm]

When using an LED as a backup light- black silicone RTV the crap out of the wire where it goes into the light. It'll save it from filling with water.

 

[highoctane]

I'm using these tail lights on my build so that I'll have a back-up light.

Not my Jeep, this pic is JAGS' Jeep. They are the Maxxima 12 LED lights, http://www.amazon.com/Maxxima-M85416...ima+tail+light. Not as bright as a set of Rigid lights, but not as expensive either, and they work fairly well.

 

[LasVegasJK]

I run the Maxximas as well, but the older version with less LEDs.