1350 Driveshaft for 2014 JKU (auto) w/ Atlas Transfer Case and PR60 front axle

supra_launch21v

supra_launch21v

New member
Need an experienced opinion. My 2014 JKU (auto) has an Atlas 2 speed installed. However, the Advanced Adapters 1350 Flat Flange is hitting the cross-member. I can adjust the clocking on the Atlas, however, they recommended that I go to their 1350 Yoke to ease installation. After talking to the drive shaft folks I am wondering if I made a bad decision using a Yoke versus the Flat Flange. They indicated the Yoke has about 25 degrees or less flex, whereas, the Flat Flange has over 30 degrees of flex. My question is: Does anyone run a 1350 CV Yoke (at the TCase) on their rig? Is there enough flex for my 12" coilovers with the Yoke?

I have been told the 2014 cross member is different than the 2012 and 2013.

Thanks, Wayne
 
A little more detail: 40 inch Nitto grapplers on slabs, Evo ultra high clearance long arms, double throw down coil overs, Pro rock 60s and Pro rock 80 full float
 
You must log in or register to reply here.
Top Bottom