Search results

I have upgraded quite a few components on the front end so I went to get an alignment. I asked to have control arms adjusted but they just adjusted toe. Jeep pulls to the left, Total toe seems high to me. Is this toe in or out? Does anyone have any suggestions on fixing the pull to the left? I...

Thanks for the help, douchebags. Ended up being bad pinion bearings.

If thats the case, how am I able to achieve proper pinion preload without crushing the sleeve?

No, I did the final measurement with the carrier removed.

Pinion preload is 25 inch lbs. Guess that means bearing, which sucks because they only have 1500ish miles on them.

It has the stock driveshaft with control arms adjusting pinion angle. I did the install so I know all the details. Pattern was confirmed good by 20 year diff builder.

I have a 2010 jk rubicon that was recently regeared to 5.13. I'm trying to chase down a noise that I noticed after the gears were changed. The pattern was good. Backlash, pinion and carrier preload are in spec. I can't recall the noise before, probably didn't pay much attention though. Noise...