Search results

A little ceramic coating action. Buffed put some minor swirls, but decided to leave the good ol trail pinstripes.... Sent from my iPhone using WAYALIFE mobile app

Decided to clean up “Ruger” since the weather was nice... "RUGER" 2016 Rubicon - Hard Rock

Swapped my Rocksport shocks and steering stabilizer over to Fox 2.0s. Maybe it’s my mind playing tricks on me, but it does feel a bit more “planted” on the road. Then again, my wallet is saying it “better” after dropping some coin and having a shop install (too cold in my garage today)...

Finally got around to get installing the Rigid Side Shots for my rear lights.... "RUGER" 2016 Rubicon - Hard Rock

Metalcloak tie rod, new G2 d-44 diff covers, 5 tire rotation and alignment, and CB install/tuning.... "RUGER" 2016 Rubicon - Hard Rock

Installed the Brawlee led light bar for the JK. Rediculous amount of light output. Wired to the back of the 12v source so I don’t have to worry about it timing out if opened for a long period. Really dig it. "RUGER" 2016 Rubicon - Hard Rock

Installed the AEV tire carrier that has been in my garage for a few weeks. Next step, hacking off the vertical post, to customize it a bit for my tastes (looks too much like a chimney pipe to me). "RUGER" 2016 Rubicon - Hard Rock

I got too excited about giving this a try and forgot about taking snaps as I went along. But here are some after the fact. I found an 1n5402 diode pack from my local radio shack... ...curled the ends of the diode (needle nose pliers will do) and soldered wires on either end. Using some heat...

Finally ally got some new shoes... "RUGER" 2016 Rubicon - Hard Rock

As an east coast transplant, I haven’t seen a good snow in a while. Loving it! "RUGER" 2016 Rubicon - Hard Rock

Depends on the type of bumper you have I suppose. With the stock Rubicon bumper, a quick large bit drill and a small file for shaping in the plastic, netted me this result. I’m really happy with the amount of light these little Rigids put out.... "RUGER" 2016 Rubicon - Hard Rock

Not my cleanest dremil tool job, but after finding the right wires for my 2016 JKU, I can see much better in reverse... "RUGER" 2016 Rubicon - Hard Rock

Dynatrac JKU brake kit and 1.5” spacers. The claims seem legit, stock pedal feel and but stopping feels stronger, with the same or a bit less of a nose dive. Either way, I’m happy. I’ll admit it, I’m still a little nervous running spacers, so I may take it to a local shop to check my torque...

Question: Is it recommended to use the small “tank” (not sure of its actual name) or is coming directly out then top of the dual ARB compressor into an air line suitable? I have the dual on my 2016 JKU with the MORE mounting bracket. Have yet to air down, or air up, so I haven’t put it through...

Small project.... Swapped out my original Rigid Industries spot windshield LEDs (purchased without paying attention to spot vs. flood....newbie mistake) with their new Rigid Side Shots. Looking forward to spreading the light wider for better visibility. Will need to adjust them to suit my...

"RUGER" 2016 Rubicon - Hard Rock

With the help of a local off road shop, Tom Woods 1350 front and rear drive shafts. (Need to peel off the cardboard from the front.) . "RUGER" 2016 Rubicon - Hard Rock

A little grill action... "RUGER" 2016 Rubicon - Hard Rock

Tatted and a pair of good pins. "RUGER" 2016 Rubicon - Hard Rock

Installed a 2.5" aFe cat back hi-tuck exhaust. Next project, Tom Woods drive shafts when the front comes in. 2016 Hard Rock Rubicon "RUGER"