Search results

After a wheeling trip six months ago I had a really bad passenger side lean, primarily up front. It was about 1.25" lower on the passenger side and after a thorough inspection nothing is broken or loose. I have since adjusted my preload in the front to level the Jeep, 1-1/8" driver side & 2"...

In the process of a DL flip, I have the synergy raised TB bracket specifically for the PR44 tube size. Before I hack the old bracket off I was going to mark the tube where the center of the current bolt hole is for the track bar. I then intend to weld in the new bracket on the same plane...

Has anyone done this successfully? The fronts don't seem to bad as I think most the the hardware went through the factory holes. The rears on the other hand may need bolted to the nutserts.....

Good Morning All, So a few months back out in AZ I took the back way to Crown King and hung up on a 4' ledge preceded by a nice size hole. I took quite a few attempts at getting up, some hard hits and eventually snapped a sway bar link (rubi E disco with aftermarket links) which in turn took...

I kept hearing a noticeable clunking every time I would change steering direction and thought it was a worn drag link end as I tore the boot some time ago trying to get it off when swapping axles. I tested all of the tie rod and drag link ends with channel locks and they are tight. I narrowed...

My actuator magnet in my front locker is too weak to pull the ring over and lock up the front axle. I have the new actuator but can't find a write up describing the install. I'm thinking -Mark and remove the caps. -Remove carrier noting shim placement and bearing race orientation. I'll likely...

Does anyone know if the MORE Dual battery tray will interfere with the EVO Bolt on Coilovers? I'm looking at installing one after the other and am thinking the ribs underneath the battery tray are the ones I'm supposed to trim when installing the front passenger coilover tower.

I have an Evo Bolt on coilover kit, but am missing most of the hardware. I'm trying to get sizes on the bolts I'm missing and am having trouble as they are not listed individually in the install instructions. Evo said call King and that they don't know off hand. KING said the kit is made to...

Hi All! I have a 07 JKR and have used the site as a resource, now its time to give back too!:beer: