cozdude's latest activity

When you and Jerry wanna go I will be ready and hopefully available lol

GMRS showed up today. Hope to get it installed asap.

My old Yukon set had a normal bearing and so did my revolutions I just installed.

Sucks. I know they changed the rear pinion bearings to a shitty roller bearing design to “increase fuel mileage”. It’s the reason all...

Got everything replaced today, pan was a simple swap, gasket is part of the windage tray and dealer said didn’t need to replace unless...

Cut off wheel. Sanding disk to round the edges

On the Overland kit you get new end links front and rear. They are threaded on both ends (one would assume right and left hand threads)...

Just cover the intake opening. Don’t worry about covering the battery. Use low pressure and go at it. Everything is exposed to the water...

Yes I have cut them to size before. Do it last once your jeep is on the ground. Once on the ground set the swaybar to about 5* above...

All I see is a pile of parts accumulating!!! Your parts horder!!!!!!!

http://wayalife.com/threads/passenger-side-bracket.64009/

Just ordered the KC Cyclone v2 two light add on kit plus both 2 and 6 pack magnet kits. I'll order the pack of 6 lights in a couple weeks.

Update: Runs as good as before. of course the tune up has helped it run smoother and actually helps it run a lot better (tune up?)...