Bullwinckle's latest activity

Hey everyone. Im Blake and this is my wife Sherry, As always we love the new years run!! Would love to see everyone again!!! Cheers...

I went on a NY run with yall in 2015 when my JKU was stock. I’d like to go again. It’s Renay. The Jeep is a little bigger and I’m a lot...

Here's a Reel that Cindy made from our hike :)

He’s busy with those gay biker things now.

Also found the plaque from the boiler the gauge came from. And for the generator it powered

Thanks! Got the gauge installed today, also replaced the old shut off valve with a new ball valve

Rebuild of the shop air compressor over the past few weekends. The air tank finally rotted out and after shopping new and used air...

I'm running the EVO 2.5 plushride in the front with a .75 inch spacer... 4.5 EVO HD plushrides in the rear... This makes it sit level...

Even though it's a JT and not a JL. The front is the same. Has 35's and the LOD Destroyer stubby front bumper, with a Warn 10s.

A steel front bumper and winch will cause your front end to sag about 3/4". Coil spacers of the same height can address that. That said...

I just recently purchased the jeep below. I would like to add a stubby bumper with winch and after market or high line fender’s. With...

Just ordered 2 3 gallon rotopax gas containers. They have up to 30% off for black friday

Welcome to Wayalife!

I have been a part of the off-roading community for several years with several platforms from side by sides to raptors. I just purchased...